Table of Contents
Advertisement
ii i_i
FOR USE
Plug the incoming cable into the ANT. jack on the rear of the unit.
If your cable service supplies you with a converter box or if you use a satellite system, connect the box with
this unit as shown below.
Antenna
Incoming cable from Cable Company
or Satellite Antenna
I/
_
o _.
/I
Rear of the unit
cab e from home
_
_,_,,,m,,,,
_
ncoming
-,_=_
.,,_z
Antenna / Cable Company
\
(No Cable Box)
Cable Box or Satellite B
*NOTE
(DO NOT DISCONNECT
FROM BOX)
Some cable TV systems use scrambled
signals and require a special converter to
receive these channels. Consult your local
cable companj4
NOTE:
Bent pin
Before plugging the antenna into
_q
the ANT jack of the unit, check
that the pin is not bent. If it is bent,
Cable
Plug
straighten the pin as illustrated,
then plug the pin into the ANT jack
(Needs to be
of the unit.
straightened)
(Straight pin)
For your safety and to
avoid damages
to the unit,
unplug the antenna cable
from the ANT. jack before
moving the unit.
When you watch a program recorded on another source (VCR or video camera), use the
AUDIO/VIDEO
input jacks on the front of the unit.
Connect the Audio/Video output jacks of another source to the AUDIO L/R and VIDEO
jacks of this unit.
Then use [SELECT]
or [CH. A / V] until "AUX" appears
on the screen.
AUX
ex.
VCR or video camera,
etc.
@@®®®_
(OUT)
To the Audio output jacks
Audio Cable
(commercially
available)
[Frontof the unit]
(OUT)
To the Video output jack
) (IN)
Video Cable
(commercially
available)
NOTE:
When you connect a monaural VCR (another source) to this unit, connect the Audio output jack of the monaural VCR
(another source) to the AUDIO Ljack of this unit. The audio will output in both L and R channel equallj4
EN
Advertisement
Table of Contents
