Brother Laura Ashley Innov-ís NX2000 Instruction Manual page 9

m
Lightly hold the end of the upper thread, and
then turn the handwheel toward you so the
mark on the handwheel aligns with the line on
the machine.
n
Gently pull the upper thread to pull up the
bobbin thread through the needle plate.
→ A loop of the bobbin thread comes out through the
hole in the needle plate.
o
Use the presser foot lever to raise the presser
foot.
p
Insert tweezers through bobbin thread loop
and pull bobbin thread above the needle
plate.
q
Align the upper thread and bobbin thread,
and then pull out about 10 cm (approx.
4 inches) of the threads and pass them under
the presser foot toward the rear of the
machine.
r
Install the needle plate cover and the cord
guide bobbin cover (for bobbin work and
attaching cords).
For details on installing the needle plate cover,
refer to "Cleaning the Race" in the Operation
Manual.
a
Needle plate cover
b
Cord guide bobbin cover (for bobbin work and
attaching cords)
CAUTION
• When creating bobbin work, use the cord guide
bobbin cover (for bobbin work and attaching
cords), otherwise the thread may become tangled
or the needle may break.
Note
• When installing the needle plate cover, do not allow
it to pinch the thread.
s
Install the flat bed attachment.
Note
• When installing the flat bed attachment, do not allow
it to pinch the thread.
t
Press or
screen.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
Note
• When the bobbin thread is replaced with a new one,
be sure to repeat the procedure from
the lower threading will not be done correctly.
in the
a
, otherwise
7