How To Diagnose Trouble In Outdoor Unit - Toshiba RAS-13UAV-E2 Service Manual

10-7. How to Diagnose Trouble in Outdoor Unit

10-7-1. Summarized inner diagnosis of inverter assembly
Diagnosis/Process flowchart
Remove
connector of
compressor.
NG
Check 15 A fuse
(Part No.F01).
OK
Replace fuse.
Check
NG
terminal voltage
of electrolytic
capacitor.
OK
NO
Does outdoor
fan rotate?
YES
Does LED on control
board flash or go on?
NO
Remove connector
CN300 of outdoor
NG fan motor, and using
a tester, check
resistance value
between every phase
at motor side
OK
Replace
outdoor
fan motor.
A B
Table 10-7-1
Item
Preparation
Check
Check
Check
electrolytic
capacitor,
diode block
(DB01), etc.
Check
electrolytic
capacitor,
diode
(DB01), etc.
Operation
Measurement
YES
Check
Stop
Check
Measurement
C
Contents
Turn "OFF" the power
breaker, and remove 3P
connector which connects
inverter and compressor.
Check whether 25 A fuse
on the control board
assembly is blown or not.
(F01)
Turn on power breaker, and
operate the air conditioner in
COOL mode by short-circuit
of the timer.
Measure terminal voltage of
electrolytic capacity.
500 F: 400WV x 3
After operation, turn off the
power breaker after 2
minutes 20 seconds passed,
and discharge the electrolytic
capacity by soldering iron.
Check voltage between
motor phases.
Is not winding
between 1-2, 2-3, or
1-3 opened or
short-circuited?
Is not frame grounded with
1, 2 or 3?
– 65 –
FILE NO. SVM-03008
Summary
If fuse was blown,
be sure to check the
electrolytic capacitor
and diode block. (DB01)
Connect discharge
resistance (approx.
100 40W) or soldering
iron (plug) between +, –
terminals of the electrolytic
capacitor (500 F)
of C14 (with printed
CAUTION HIGH VOLT-
AGE) on P.C. board.
Discharging position
Plug of
(Discharging period
soldering
10 seconds or more)
iron
OK if 500 F
DC280 to 380 V
Remove CN300 by pushing
the part an arrow because
CN01 is a connector with
lock.
Resistance between
phases should be approx.
55 to 77 .
Should be 10M or
more.