GE Spacemaker Laundry WSM27TH Use And Care Manual page 16

Care and Cleaning
(continued)
Do not store items or
cleaning products on top
of the Laundry Centre.
Outside
• When laundering is completed, wipe cabinet with a damp cloth. Turn water
faucets off to prevent pressure build-up in the hoses.
Do not store items or cleaning products on top of the Laundry Centre.
Be careful when handling laundry products. They can damage the finish
on the appliance and control panel.
• Clean the cabinet with mild soap and water. Never use harsh, gritty or
abrasive cleansers. If the cabinet becomes stained, clean with diluted chlorine
bleach [1/2 cup (120 ml) in 1 quart (.95 L) water]. Rinse several times with clear
water.
• Remove glue residue from tape or labels with a mixture of warm water and mild
detergent. Or, touch residue with the sticky side of the tape or label.
• Before moving the laundry center, place a strip of cardboard or thin
fiberboard under the front leveling legs to prevent floor damage.
Tinting
If tints and dyes are used in the washer, some washer parts, such as the agitator and
tub, will take on the colour of the dye. The colour will not harm the parts andwill
not transfer to future loads if the washer is cleaned as directed.
After tinting, wipe any splashings from the cabinet and lid. Then run the washer
through a hot cycle using detergent and bleach.
When using tints or dyes, always follow the package instructions. Be sure that items
to be dyed are machine washable. Please note the tinted clothes will not be
colourfast and should be washed seperately to avoid transferring colour to other
garments.
Winterizing Instructions
If the laundry center is stored in an area where freezing can occur or moved in
freezing temperatures, follow these winterizing instructions to prevent damage to
the laundry center:
1. Turn off water supply faucets.
2. Disconnect hoses from water supply and drain water from hoses.
3. Plug electrical cord into a properly grounded electrical outlet.
4. Add 1 gallon nontoxic recreational vehicle (RV) antifreeze to empty wash
tub. Close lid.
5. Set cycle selector knob at a spin setting. Pull out knob and let washer spin for
1 minute to drain out all water. Not all of the RV antifreeze will be expelled.
6. Push in knob, unplug electrical power cord, dry tub interior, and close lid.
7. Store washer in an upright position.
8. To remove antifreeze from washer after storage, run empty washer through a
complete cycle using detergent. Do not add wash load.
16