Advertisement
Step 5.
Using provided screwdriver, remove the M4 x
0.7 screws that hold the display assembly to-
gether, then separate the back of the display
from the front.
Note: Retain the screws for later use.
Step 7.
Line up the four holes of the mounting bracket
with holes of the neck, then insert four 6mm x
50mm socket head cap screws.
7
Step 6.
Slide the back of the display with the mounting
bracket onto the upper neck of the Total Body
Trainer.
Caution: Be careful not to pinch any cables between
the two sections of the assembled neck
Step 8.
Using provided 5mm hex key, tighten down the
screws to 240 in-lbs (27 N-m).
620-7921 Rev A
Advertisement
