Table of Contents
Advertisement
o
Other errors that can be corrected without turning the
printer off.
After these printer errors are corrected, the fax board starts to
print the received fax data automatically.
When the fax board stops receiving a fax
The fax board stops receiving fax data in the following
situations:
o
Service request error (SERVICE REQ on printer's LCD)
o
Fax reception buffer full
o
Fax sender quits sending the fax
o
Loss of phone line connection
o
Protocol mismatched between the fax board and the other
fax machine.
If one of these should occur, all or some part of the received fax
data may be lost.
Wrong printer error
The fax board operates in the EPSON printers listed in the
Introduction. If it is installed in any other printer, it may not
print, it may print garbage, or it may print the following
message:
This card cannot be used in the printer. Pull out the card.
TYPE-B INTERFACE CARD
Ver Fl.xx / Vl.xxA
STATUS CODE xxxxxxxx
SEIKO EPSON CORPORATION
Troubleshooting
10
Advertisement
Table of Contents
