Before Using Forthefirst Time; Getting Started; Preparations For Washing - Bosch SHU3030 series Use & Care Manual

Hide thumbs Also See for SHU3030 series:
Table of Contents

Advertisement

BEFORE USING FORTHEFIRST TIME
Before beginning to use your dishwasher for the first
time:
l. Check to make sure that the voltage on which the
dishwasher is to operate is the same as shown on
the rating plate.
2. Check to make sure that the water valve to the
dishwasher is open. The installer may have closed
the valve upon completing the installation.
Start and Run Knob
/
BOSCH
_les
SHU 3030 Series
Control Panel
I
On/000 _
High Regular Rinse
Temp
Temp
$ Hold
Wash
wash
On/Off
Handle
Button
Temp Op_o_s
Figure 2.
GETTING STARTED
The operation of your Bosch dishwasher is summarized
below:
1.
Load the dishwasher.
Refer to Table l for items suitable for washing in the
dishwasher. The dishwasher should be loaded with
pots, pans, dishes and silverware according to the
instructions provided under the following section
titled LOADING.
2.
Add detergent and check rinse agent.
Detergent must be placed in the detergent dispenser
compartment as described in the following section
titled DETERGENT
USE. The use of a rinse agent is
required to ensure good cleaning and drying result.
See section titled RINSE AGENT DISPENSER.
3.
Check motion of wash arms.
The wash arms must be free to move and should not
be blocked by any item extending so far above lower
rack as to block upper arm or by any items hanging
below either the upper or lower rack to obstruct the
motion of the wash arms. See following section titled
OPERATION.
4.
Close the door of the dishwasher.
Make sure that the door is completely closed and latched.
5.
Select a wash cycle, see Table 2.
6.
Start the dishwasher.
Turn the "Start and Run Knob" to the cycle you desire
(Power Scrub or Regular Wash). Then choose the
temperature option you want for the cycle you chose
by depressing the "High Temp. Wash" or the "Regular
Temp. Wash" buttons. If you choose the "Rinse and
Hold" Cycle on the "Start and Run Knob", then you
also need to choose the Rinse & Hold" button. After
you are finished selecting your cycle and temperature,
then depress the On/Off button. The indicator light
above the On/Off button will become illuminated and
the dishwasher will start. The "Start and Run Knob"
7,
will rotate clockwise as the dishwasher cycle progresses.
It is possible to discern at what stage the cycle is in,
by noting the position of the knob indicator.
To stop dishwasher.
Depress the On/Off button. The indicator light above
the On/Off button will turn off. See the following
section titled TO INTERRUPT
OR RESET CYCLE.
PREPARATIONS FOR WASHING
Very little preparation is required before placing dishes,
pots, pans, etc. into the dishwasher. However, some
preparation is required:
Large solids, such as, bones, large seeds, shells, skins,
leafy vegetables, meat trimmings, etc. should be
removed either by scraping into a wastebasket, or into
your food disposer.
Large amounts of any type of leftover food should also
be scraped into a wastebasket or into your food disposer.
Pots and pans that have burned-on food, the food is
blackened, should be pre-soaked and scoured. The
dishwasher cannot remove burned-on food.
Do not place the following items in the dishwasher:
> toothpicks
> small bones and bone slivers
> paper products such as paper plates and paper
napkins
> plastic bags or plastic packaging material.
In general,
try to remove food scraps and place the items
to be washed
in the dishwasher
before the food has had a
chance
to dry-on.
Dried-on
food is more difficult
to
remove.
If there will be an extended
period of time before
the dishwasher
will be run it is recommended
that the
"Rinse
& Hold" cycle be used.
Other than the above, no special
preparation
or pre-rinsing
is required
for dishes, pots and pans or utensils
with
normal amounts
of food soil.

Advertisement

Table of Contents
loading

Table of Contents