Hitachi CP-X467 Network Manual page 70

4. Management with Web browser software
4.1 Configuring and controlling the projector via a web browser (Continued)
Item
Wireless Mode
CH
(Communication
channel)
Speed
(Communication speed)
Encryption
WEP Key
WPA Passphrase
SSID
Click [Apply] button to save the settings.
NOTE
• The new configuration settings are activated after restarting the
network connection. When the configuration settings are changed, you must
restart the network connection. You can restart the network connection by
clicking [Network Restart] on the main menu.
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
• The WEP Key, WPA passphrase and SSID settings will not be set if the invalid
characters are used.
70
Select "AD-HOC" or "Infrastructure".
Select using channel between "1" and "11".
NOTE
• Depending on the country where you are
the channels may vary. In addition, depending on
the country or region where you are may be required
to use a wireless network card that confirm to the
standards in the respective country or region.
Select communication speed.
Select data encryption method.
Input WEP key, which has same length defined by WEP.
When "64bit" or "128bit" is selected, input 10 characters or
26 characters respectively. Only numbers from "0" to "9"
and alphabets from "a" to "f" (whichever small or capital
characters) can be used.
Enter the series of two characters pair. It will be cleared by 0,
if the total length is odd.
Input WPA Passphrase. Available number of input characters
is 8 to 63. Only alphabets, numbers and following symbols
can be used.
!"#$%&'()*+,-./:;<=>?@ [\]^_`{|}~ and space
Select an SSID from the list. If you require to set your unique
SSID, select [Custom], then set your own SSID following the
rules below.
Maximum number of input characters is 32.
Only alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@[\]^_`{|}~ and space.
Description