Advertisement
;E
HOW TO SET UP YOUR TRACTOR
CONNECT
BAKERY
(See Figs. 2 and 3)
CAUTION:
Do not short battery termio
hats by allowing
a wrench or any other
obieet to contact
both terminals
at the
same time,, Before conneetin 9 battery,
remove
meta_ bracelets,
wristwatch
bands, rings, etco
Positive
terminam must be connected
first to prevent sparking from acciden°
tat grounding°
o
Remove cardboard packing from seat pan and tilt seat
pan to raised position.
o
Open battery box door and remove protective ptastic.,
o
Remove terminal protective caps and discard.
o
if this battery is put into service after month and year
indicated on labe_ (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
First connect RED battery cable to positive (+) terminal
with hex bo_t, flat washer, lock washer and hex nut as
shown. Tighten securely.
o
Connect BLACK grounding cable to negative (-) termi-
na! with remaining hex bolt, flat washer, lock washer
and hex nut. Tighten securely.
•
Close battery box door.
Open battery box door for:
•
Inspection for secure connections
(to tighten hard-
ware).
,
inspection for corrosion.
•
Testing battery.
•
Jumping (if required).
o
Periodic charging.
POSiTiVE
(RED) CABLE
D_SCARD TERMINAL
PROTECTIVE
CAPS
LOCK
HEX
WASHER
NUT
FLAT
WASHER
NEGATIVE
(BLACK)
CABLE
FiG° 2
BOLT
SEAT
PAN
BATTERY
BOX DOOR
FiG. 3
INSTALL
SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
•
Remove cardboard packing on seat pan.
®
Place seat on seat pan and assemble shoulder bolt.
Tighten shoulder bait securely.
o
Assemble adjustment bolt, lock washer and flat washer
loosely.
Do not tighten.
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached which
allows you to press clutch/brake
pedal all the way
down.
,
Get off seat without moving its adjusted position.
Raise seat and tighten adjustment bolt securely.
SEAT
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
BOLT
FLAT WASHER
LOCK WASHER
FJGo4
8
Advertisement
