Advertisement
The operation of any lawn mower can
result in foreign objects thrown into the
eyes, which can result in severe eye
damage. Always wear safety glasses or
eye shields while operating your lawn
mower or performing any adjustments or
repairs. We recommend a wide vision
safety mask over spectacles or standard
safety glasses.
HOW TO USE YOUR LAWN
MOWER
ENGINE
SPEED
CONTROL
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
&CAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk of
blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST
CUTTING
HEIGHT
• Raise wheels for low cut and lower
wheels for high cut.
• Adjust cutting height to suit your
requirements.
Medium position is best
for most lawns.
• To change cutting height, squeeze
adjuster lever toward wheel.
Move
wheel up or down to suit your require-
ments.
Be sure all wheels are in the
same setting.
NOTE:
Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lower wheels for
high cut
Raise wheels for low
cut
Le_ver
Plate tab
TO ATTACH
GRASS
CATCHER
• Close the flip lid. Flip lid must be closed
while operating lawn mower.
• Lift the rear door on the mower housing
and place the grass catcher frame onto
the formed tabs on the rear door hinge
bracket.
• The grass catcher is secured to the lawn
mower housing when the rear door is
lowered onto the grass catcher frame.
&,CAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place.
Never attempt to
operate the lawn mower with the rear door
removed or propped open.
bracket
Formed
tabs
Grass
frame
TO EMPTY GRASS CATCHER
• To remove grass catcher, release
operator presence control bar to stop
engine:
• Lift up rear door and remove the grass
catcher by the handle.
NOTE: Do not drag the bag whdn
emptying;
it will cause unnecessary
wear.
BEFORE
STARTING
ENGINE
OIL
Your lawn mower
is shipped
without oil in
the engine.
• Be sure mower is level and area around
oil fill is clean.
• Remove
engine oil plug and fill to the
top of slot in filler hole.
• Use 20 ozs. of oil.
For type and grade
of oil to use, see "ENGINE"
in Mainte-
nance section
of this manual.
• Pour oil slowly.
Do not over fill.
• Check oil level before each use. Add oil
if needed.
6
Advertisement
