Read And Follow Safety Instructions; Electrical Safety; General Safety - Craftsman 390.2522 Owner's Manual

READ AND FOLLOW SAFETY INSTRUCTIONS!
A
WARNING 1
A CAUTION 1
This is the safety alert symbol. When you see this symbol
on your pump or in this manual, look for one of the fol-
lowing signal words and be alert to the potential for per-
sonal injury:
DANGER warns
about hazards
that will cause serious per-
sonal injury, death or major property damage if ignored.
WARNING warns about hazards that will or can cause se-
rious personal injury, death or major property damage if ig-
nored.
CAUTION warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which are
important but not related to hazards.
Carefully read and follow all safety instructions in
this manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
Electrical Safety
A WARNING
Hazardous voltage.
Can shock, bum, or
cause death.
Ground pump before
connecting to power
supply.
_k Wire motor for correct
voltage. See "Electrical"
section of this manual
and motor nameplate.
_k Ground motor before
connecting to power
supply.
Meet National Elect-
rical Code and local
codes for all wiring.
Follow wiring instruc-
tions in this manual
when connecting mo-
tor to power lines.
Make workshops childproof; use padlocks and master
switches; remove starter keys.
General Safety
Do not allow pump, pressure tank, piping, or any other sys-
tem component containing water to freeze. Freezing may
damage system, leading to injury or flooding. Allowing
pump or system components to freeze v_dl void warranty.
General Safety
WARNING
Hazardous pressure!
Install pressure relief
valve In discharge pipe.
Release all pressure on
system before working on
any component.
Relief valve must be capable of passing full pump flow at
75 PSI.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, tmclunered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
AWARNINGIPump body
may explode if used as a
I
booster pump unless relief valve capable of passing
full pump flow at 75 PSI (517 kPa) is installed.
[_ CAUTION ]Motor normally operates at high temperature
and will be too hot to touch. ]t is protected from heat dam-
age during operation by an automatic internal cutoff
switch. Before handling pump or motor, stop motor and
allow it to cool for 20 minutes.
2