Craftsman 358.351161 Operator's Manual page 5

• Low-Kickback Chain, has met kick-
back performance requirements when
tested on a representative sample of
chain saws below 3.8 cubic inch
displacement specified in ANSI
B175.1_
Low-Kickback Chain
Contoured Depth Gauge
AEDIne°_e_li_ d/_Gc _l_rdklJ_okr c e
Chain With High Kickback Potential
__ Can Obstruct Material
SAFETYNOTICE: Exposure to
vibrations through prolonged use of
gasoline powered hand tools could
cause blood vessel or nerve damage in
the fingers, hands, and joints of people
prone to circulation disorders or
abnormal swelling. Prolonged use in
cold weather has been linked to blood
vessel damage in otherwise healthy
people. If symptoms occur such as
numbness, pain, loss of strength,
change in skin color or texture, or loss
of feeling in the fingers, hands, or joints,
discontinue the use of this tool and
seek medical attention. An
anti-vibration system does not
guarantee the avoidance of these
problems. Users who operate power
tools on a continual and regular basis
must closely monitor their physica!
condition and the condilion of this tool.
CHAIN BRAKE If this saw is to be used
for commercial logging, you must order
and install a chain brake to comply with
Federal OSHA Regulations for Com-
mercial Logging. Contact your Sears
Service Center, or call 1-800-235-5878.
SPARK ARRESTOR: Your saw is
equipped with a temperature limiting
muffler and spark arresting screen
which meets the. requirements of
California Codes 4442 and 4443. All
U.S. forest land and the states of
California, Idaho, Maine, Minnesota,
New Jersey, Oregon, and Washington
require by law that many internal
combustion engines be equipped with a
spark arrestor screen, If you operate a
chain saw in a state or locale where
such regulations exist, you are legally
responsible for maintaining the
operating condition of these pads.
Failure to do so is a violation of the law.
Refer to the CUSTOMER RESPON-
SIBILITIESsection.
STANDARDS: This chain saw is listed
by Underwriters Laboratories, Inc. in
accordance with American National
Standards for Gasoline-Powered Chain
Saws Safety Requirements (ANSI
B175.1-t991).
CARTON CONTENTS
Check carton contents against the fol_
lowing list,
• Models 351081, & 351161
• Chain Saw (fully assembled)
• Chain adjustment tool
• 2-cycle engine oil, (Bar oil not
included)
• Examine pads for damage. Do not
use damaged parts.
• If you need assistance or find parts
missing or damaged, please call
1-800-235-5878.
NOTE: It is normal to hear the fuel filter
rattle in an empty fuel tank.
Your unit has been factory tested and
the carburetor precisely adjusted. As a
result you may smell gasoline or find a
drop of oil/fuel residue on the muffler
when you unpack the unit.
ASSEMBLY
Your saw is fully assembled, and no
assembly is necessary.