Craftsman 358.795631 Operator's Manual page 9

i i i
OPERATION
HOWTO USE YOUR HEDGE TRIMMER NOTE'
Verity the throttle trigger stays in the advanced
STOPPING YOUR ENGINE
• Move start/stop switch to the "STOP" position.
• If engine does not stop, pull choke knob out fully.
THROTTLE CONTROL GROUP (Fig. 2)
THROTTLE LOCKOUT
• The throttle lockout prevents unintentional actuation of
the throttle trigger.
• You must depress the throttle lockout with the palm of
your hand before actuating the throttle trigger.
THROTTLE TRIGGER
• The throttle trigger allows for variable control of engine
speed.
• The throttle trigger is actuated by the index fingeron your
right hand. (After the throttle lockout is depressed).
THROTTLE LOCK
• The throttle lock allows the faster engine speeds during
starting.
• The throttle lock is engaged by the following steps:
- Grasp the rear handle and depress the throttle lockout.
- Squeeze the throttle trigger fully and hold.
- Depress the throttle lock w_thyour forefinger and hold.
- Release your grip on the throttle trigger and throttle
lockout.
position.
• Squeezing the throttle trigger will release the fast idle
setting. If the throttle trigger is squeezed accidentally
during starting, it will be necessary to reset throttle lock.
CHOKE
• The choke is set by pulling the choke lever out .fully for
coldor refueled engine starts.
PRIMER BULB
• The primer bulb is used to circulate fuel to the carburetor.
• The primer bulb is activated by pressing on it with your
thumb.
PRIMER
BULB
CHOKE THROTTLE
ON/OFF LOCK
THROTTLE
TRIGGER
Figure 2
,9,