Advertisement
Quick Links
/ CRIIFT, SIHIilN
PREMIUM
CHESTS AND ROLL-A-WAYS
WITH
KEY LOCKS
ASSEMBLY
INSTRUCTIONS
MODEL #'S 706.657840,
706.657850,
706.6578_0,
706.657870,
706.657890
706.127280,
706.127290
PLEASE READ ALL INSTRUCTIONS
CAREFULLY
SAVE
THIS
MANUAL
FOR FUTURE
P_i_F_RENCE
Our Tool Chests and RolI-A Ways are designed to give you the finest
appearance, convenience, and storage for year_ of service.
Prior to loading
drawers with tools, lubricate the top channel and bottom channel of drawer
slides (see drawer slidesection) with oil or petroleum jelly. This should be done
several times a year.
HELPFUL HINTS:
Make sure all drawers are completely closed and locked when moving i_r
unit. Two keys are
provided in the event that one is lost. Keep the other key in a safe plaEE
D0 NOT keep your
spare key inside the unit.
DRAWER SLIDES: If it becomes necessary to remove drawers, follow these drawer removal _structions:
A) Pull drawer all the way open then push back a fraction of an inch.
B) Insert a screwdriver into this slot in the slide and push in on the stop
until it clears the lance. Repeat the procedure on the other slide and
remove drawer.
C) To reinstall drawer, pry stop far enough out to engage fiance(3/16"
to 1/4") and push drawer onto slides until stops engag$ lances.
CA_TER INSTALLATION: Lay the roll-a-way on its back. _'osition and
attach the two rigid easters to one end of the roller cabin_ using four
of the 1\4-20 bolts and four of the 1/4-20 nuts provided in,he bolt bag
for each. Wrench tighten. Position the other two casters (the one with the brake goes on Ifront
side of the unit)
in the same manner and attach with four 1/4-20 bolts and four 1/4-20 nuts. Wrench tight_
LOCKING YOUR UN_:
TO LOCK CHEST: Insert the lock bars, into the slots in this top tray and down into the Slots qn the base. Close the
cover and turn key to lock.
TO LOCK ROLL-A-WAY_ Insert lock bar into slot in center of base. Move the lock bar towaiii=t;le unit until the other
end fits into the slot in the top next tO the lock and turn key to secure.
TO UNLOCK CHEST AND ROLL-A-WAY: Reverse'these procedures.
NOTE: The chest lock bars are stores in the.top tray of chest and the roll-a-way lock bar ot_Ees in the slots located
on the top front corners of the cabinet.
PANEL: if your unit is equipped with a storage compartment with a panel at the bottom, pull p=qlalout, lift up and push
panel back into unit to gain access to storage compartment.
Replacement Parts can be ordered by calling
toll free 1-800-366-7278,
'
Printed in the U.S.A
F665A1
sold by SEARS, ROEBUCK AND CO,, Hoffman Estates, IL 6017111J,S,A,
_/_€
F917
Advertisement
