Advertisement
i!!ili ii!iiiii!iiiiii!iii!ili!iii!
i
GENERAL
An occasional coat of paste wax on the work table wilt
allow the wood being cut to glide smoothly across
work surface.
MOTOR
if the power cord is worn, cut or damaged in any way,
METHOD OF OILING BEARINGS
have it replaced immediately.
1. Turn saw on its side.
Do not attempt to oil the motor bearings or service the
motor internal pads.
2. Squid a generous amount of SAE 20 oil around the
shaft end and bronze bearing.
ARM BEARINGS
3. Let the oil soak in overnight in this position.
Lubricate the arm bearings after 10 hours of use. Re-oil
after every 50 hours of use or whenever
there is a
4. Ne×tday repeat the above procedure for the opposite
squeak coming from the bearings,
side of the saw,
recommends
the following
accessories
Item
Blades:
See catalog for 5" long; plain end type
blades
Medium radius cuts in wood up to 1-1/2"
Fine radius cuts in wood up to 1/4" thick
Sears may recommend other accessories not listed in
the manual.
See your nearest Sears store or Catalog
department for other accessories.
Dc not use any accessory unless you have received and
read complete instructionsfor its use.
16
Advertisement
