Putting Into Operation - Gardena 7874 Operating Instructions Manual

G
Summary Operating Instructions
1 2
Insert the battery 1. Press the On/Off
in the GARDENA key. Keep the
Radio Remote On/Off key pressed
Control Unit. down while plug-
ging the GARDENA
Use a 9 V alkali- Remote Control
manganese (alkaline) Socket into a 230 V
battery Type IEC AC mains socket.
6LR61 and observe
the +/- markings. 2. Release the On/Off
key after 5 seconds.
18
3 4
Assigning keys of the 1. Plug the devices
GARDENA Radio you wish to control
Remote Control Unit remotely into the
to the corresponding GARDENA Radio
socket: Remote Control
Socket and switch
While the LED on on.
the Remote Control
Socket is flashing, 2. You can now switch
press one of the devices on and
On keys on the off using the Radio
GARDENA Remote Remote Control
Control and hold Unit.
down for 1 second.

Putting into Operation

Insert the battery x Take the lower half of the housing from your GARDENA Radio
Remote Control Unit by unscrewing the 4 screws.
x Insert a 9 V alkali-manganese (alkaline) battery Type IEC 6LR61.
Please note the +/- markings.
x Screw the unit together again.
Plugging the Ensure you have both your GARDENA Radio Remote Control Sok-
ket and GARDENA Radio Remote Control Unit close at hand.
Radio Remote
Control Socket
into the Power x Press the On/Off key of your GARDENA Radio Remote Control
Outlet Socket. Hold the key down (
plug the Radio Remote Control Socket into a 230 V AC power
outlet.
x Your GARDENA Radio Remote Control Socket changes the
assignment mode; the red LED stays lit.
x Release the On/Off-key (LED flashes). Now you have 10 seconds
to assign the socket to a key on your Radio Remote Control Unit.
Select an (unassigned) key of the Remote Control and hold
down the corresponding "ON" key, located on the left-hand side,
for 1 second. The red LED stays lit for approx. 2 seconds once
you have successfully assigned the socket.
G
for at least 5 seconds) while you
19