Gigabyte GV-RX80T256V User Manual page 7

4. Locate the PCI Express x 16 slot. If
necessary, remove the metal cover from
this slot; then align your graphics card with
the PCI Express x 16 slot, and press it in
firmly until the card is fully seated.
5. Replace the screw to fasten the card in
place, and replace the computer cover.
6. Plug the display cable into your card; then
turn on the computer and monitor. If your
graphics card came with a DVI connector,
you can connect a flat panel display to the
appropriate connector, as shown below...
To VGA Monitor
To Flat Panel Display
You are now ready to proceed with the installation of the graphics card drivers. Please
refer to next chapter for detailed instructions.
After installing the GV-RX80T256V to your computer, please
remember to connect at lease one power cable on the
graphics card to the power supply connector.
We suggest you to connect both of the two power cables on
the graphics card to the power supply to achieve optimcal
graphics performance.
9 Pin(VIVO)
- 7 - Hardware Installation