Advertisement
How To Use Your Pressure
Washer
On the end of your spray gun is a nozzle that you can
slide forward and backward and that you can also
twist from side to side. With the adjustable nozzle you
can adjust the spray pattern to either high pressure
or low pressure. You can also adjust the spray so it is
concentrated in a stream pattern or expanded into a fan
pattem.
• Slide the nozzle in a forward position to draw chemical
and achieve low pressure. Pull nozzle back for high
pressure.
HIGH PRESSURE
LOW PRESSURE
• To adjust your spray pattern twist the nozzle
clockwise for fan spray or counterclockwisefor
stream spray.
FAN SPRAY
STREAM SPRAY
• For most effective cleaning, keep spray nozzle
between 8 and 24 inches from cleaning surface.
IMPORTANT:
If you get spray nozzle too close,
especially on high pressure,
you may damage the
surface you are cleaning.
Using Soaps/Chemicals
IMPORTANT: Use soaps and chemicals that are
designed specifically for use with pressure washers, To
apply soaps/chemicals follow these steps:
• Preparethe soap/chemical as required by yourjob.
• Insertsoap/chemical line intoyour container (soap/
chemicalsand containernot included),
CHEMICAL
HOSE --
CHEMICAL
• Slide the adjustable nozzle forward to low pressure
mode. Soap/chemicals cannot be applied with nozzle
in high pressure position.
• Review the use of the adjustable nozzle.
• Connect garden hose to water inlet (see "To Start Your
Pressure Washer" on page 9). Check that high
pressure hose is connected to spray gun and pump
(see Assembly), and start engine.
• Apply soap/chemicals to dry surface, starting from the
bottom and working up.
• Allow the soap/chemicals
to soak in between 3-5
minutes before washing and dnsing.
• When rinsingon high pressure, start at lower portion
of area to be washed and work upward, using long,
even, overlapping strokes.
10
Advertisement
