Checklist Before Starting Engine - Craftsman 580.767450 Owner's Manual

2. Remove anddiscard shipping capsfrompumpinlet 7. TurnONwaterandsqueeze trigger o n spraygun
andoutlet, to purge pumpsystem of airandimpurities.
3. Attach otherendof highpressure h oseto high
pressure outlet o n pump. T ighten by hand.
Inspect i nlet
screen. D ONOT
useif damaged;
cleanif dirty.
4.
.
Before connecting garden hose to water inlet,
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. Refer to
section "O-Ring Maintenance" if inlet screen is
damaged. DO NOT run pressure washer if inlet
screen is damaged.
Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6. Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
CAUTION
WARNING
Always wear eye protection when using this equipment
or in vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are
wearing adequate eye protection.
CHECKLIST BEFORE STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
1. Check that hose reel fasteners are tight.
2. Check that oil has been added to proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for proper hose connections (high pressure
and water supply) and that there are no kinks,
cuts, or damage to the high pressure hose.
5. Provide proper water supply (not to exceed
100°F).
6. Be sure to read "Safety Rules" and "Operation"
sections before using the cleaning system.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.