Network Functions; Network Initiator Sequences; Include Node On To This Network; I Nclusion And - Horstmann HRT4-ZW Manual

2 Network Functions

2.1 Network Initiator Sequences

The following table shows how to select the standard Z-Wave functions.
Z-Wave Function
Include Node on to this
network
Exclude Node from this
network
Transmit a Node
Information Frame (NIF)
Inclusion / Exclusion by
another controller
Inclusion and reception of
primary role
Receive Period Enabled
(Listening)
Protocol Reset
Associate Control Unit
Disassociate Control Unit
Controller Shift

2.2 Include Node on to this Network

When include has been selected the unit will wait until a successful outcome is received or a failed outcome is received and
indicate this on the LCD with a 'P' or 'F' respectively.
If the installer does not start the inclusion process of the other node within 60s, or the unit does not receive a response within 4
minutes of beginning inclusion with another node, or 5 minutes is up (60s + 4 minutes) a failed outcome will be indicated.
NOTE: If the node added to the network supports the Thermostat Mode command class or Binary Switch command class that
node will be associated in to Group 1 or Group 2 – see Figure 4.
Initiator Sequence
Using the dial find 'I' and press it to select the function.
Using the dial find 'E' and press it to select the function.
Using the dial find 'n' and press it to select the function.
Using the dial find 'L' and press it to select the function.
Using the dial find 'L' and press it to select the function.
Using the dial find 'Li' and press it to select the function.
Using the dial find 'P' and press it twice to select the function.
Using the dial find 'A' and press it to select the function.
Using the dial find 'd' and press it to select the function.
Using the dial find 'C' and press it to select the function
Table 1 – Z-Wave Function Initiators
Mode Indication
'I' flashes
'E' flashes
'n' flashes
'L' flashes
'L' flashes
'Li' flashes
'P' flashes
'A' flashes
'd' flashes
'C' flashes