Reset Procedure - Horstmann ChannelPlus H37VXL Series 2 User Operating Instructions Manual

Open cover
Press the green
'SET' button
Use the '+' and '-'
buttons to adjust
'HEADINGS'
Press 'ENTER'
Press the green
'SET' button
Press the green
'SET' button
RESETTING THE CHANNELPLUS H37VXL SERIES 2
Electronic equipment can in some circumstances be affected by electrical interference.
If the display becomes frozen or scrambled; or if you wish to revert back to the default
settings please use the following procedure:

RESET PROCEDURE

PLEASE NOTE: Using this procedure will restore the ChannelPlus to the original factory
programme settings, the time setting will remain correct.
Lower the front flap of the unit. On the right
hand Channel press the ADVANCE (Enter)
and SELECT (Blue) buttons together, then
release and the programmer will return to
the preset factory settings.
Adjusting Channel Headings
The programmer has been preset to display the channel heading
as 'Heating and Hot Water', should you require either the 'Zone'
Use the '+' and '-'

buttons to select
'SET DEFAULTS'

Press 'ENTER'
Use the '+' and '-'
buttons to adjust

HEATING/WATER
ZONES OR CHANNELS

Press 'ENTER'

Close cover
General Information
or 'Channel' options then please follow
the flowchart opposite.
SAMPLE DISPLAYS

ADVANCE
BOOST

SELECT
SET HEATING 1
SET HEATING 2
SET WATER
SET HOLIDAY MODE
SET DEFAULTS
SET DEFAULTS
SET DEFAULTS
TIME AND DATE
CLOCK OPTIONS
HEADINGS HEADINGS
HEADINGS
HEATING/WATER HEATING/WATER
ZONES
CHANNELS
RESET
11