Oki B6100n User Manual page 11

4. First, connect the power cord to the wall outlet, and then turn the printer on.
5. Check the operator panel. After the warm up and initialization cycles, it should read
. If it is blank, the Hard Disk pins are improperly installed in the connector:
READY
a. Turn the printer off, then remove the power cord from the outlet.
b. Remove the side panel from the printer.
c. Check to be sure that the Hard Disk pins—wide bank only: the separate pins should
not engage the connector—are properly seated in the connector.
d. Reinstall the side panel, plug the printer in and turn it on. Wait for the warm up and
initialization cycles to complete, then check the display for
The installation of your Hard Disk is complete.
OKI Hard Disk User Guide
Chapter 1: Installation
.
READY
7