Listening To A Non-Docking Ipod Or Other Portable Audio Device; Maintaining Your Speaker System - Altec Lansing IN MOTION IMT520 User Manual

If you have a non-iPod MP3 player or other non-docking portable audio
device, you can enjoy it through your Altec Lansing inMotion Kick speaker
system as well. Just connect it via the AUX jack. Here's how:
1
Locate a 3.5mm stereo cable
(not included).
2
Plug one end of the stereo cable
into your device.
Your device should have either a
headphone or LINE OUT jack for you
to plug into.
3
Plug the other end of the stereo
cable into your speaker system's
AUX jack.
The AUX jack is located on the back
of the unit.
4
Select "AUX" mode.
Press the "SOURCE" button on your
speaker system or the full-featured
remote until the "AUX" LED lights up.
5
Turn on your device and start it
playing.
6
Adjust the volume.
Use the "+" and "–" buttons on the speaker system or full-featured
remote to adjust the volume.
NOTE You may need to adjust the device volume also. Your device's
volume should be set to approximately ¾ volume.
7
When you are finished listening to your portable audio device,

Listening to a Non-docking iPod or Other Portable Audio Device

please remember to turn both it and your speaker system off
to conserve electricity.

Maintaining Your Speaker System

Place your speaker system on a level surface away from sources of direct
sunlight or excessive heat.
Protect your furniture with a cloth or other protective material when placing
your speaker system on a natural wood or lacquered finish.
Clean your speaker system with a soft cloth moistened only with mild soap
and water. Stronger cleaning agents, such as benzene, thinner or similar
materials, can damage the surface of the unit.
13