Advertisement
Positive Terminal
Negative Terminal
C
ed
Battery
Positive Terminal
Negative Terminal
REPLACING
BATTERY
A CAUTION:
Do not short battery
terminals by aUowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch
bands,rings,etc,
Positive terminal must be connected first
to prevent sparking from accidental
grounding.
• Lift seat pan to raised position and
open battery box door.
• Disconnect
BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
• Install new battery with terminals in
same position as old battery.
• First connect RED battery cable to
positive (+) terminal with hex bolt and
nut as shown. Tighten securely.
• Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and nut. Tighten securely.
• Close battery box door.
Seat
Ba_e_
Doc
Box
Nut
Hex
Positive (Red) Cable
Cable
(Black)
TO REPLACE HEADLIGHT
BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside
of the grill.
• Replace
bulb in holder and push bulb
holder securely
back into the hole in
the backside
of the grill.
• Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring.
See electrical
wiring
diagram
in the Repair Parts section.
TO REPLACE
FUSE
Replace with 15 amp automotive-type
plug-in fuse.
The fuse holder is located
behind the dash.
TO REMOVE
HOODAND
GRILL
ASSEMBLY
• Raise hood.
• Unsnap
headlight wire connector.
• Stand in front of tractor.
Grasp hood at
sides, tilt toward engine and lift off of
tractor.
• To replace, reverse above procedure.
Headlight Wire
Connector
25
ENGINE
Maintenance,
repair, or replacement of
the emission control devices and
systems, which are being done at the
customers expense, may be performed
by any non-road engine repair estab-
lishment or individual. Warranty repairs
must be performed by an authorized
engine manufacturer's service outlet,
TO ADJUST THROTTLE
CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not
be necessary. Check adjustment as
described below before
loosening
cable. If adjustment is necessary,
proceed as follows:
Advertisement
