Service And Adjustments; To Remove Mower; Side-To-Side Adjustment - Craftsman 944.609940 Owner's Manual

SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
Turn Ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TO REMOVE MOWER (See Fig. 18)
• Place attachment clutch in =DISENGAGED" position.
• Turn height adjustment knob to lowest setting.
• Lower mower to its lowest position.
• Remove retainer spring holding anti-swaybar to chas-
sis bracket and disengage anti-swaybar from bracket.
• Remove retainer springs from suspension arms at
deck and disengage arms from deck.
• Raise attachment lift to its highest position. :
• Remove two retainer springs from each front link and
remove links.
• Slide mower forward and remove belt from electric
clutch pulley.
• Slide mower out from under right side of tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
TO INSTALL MOWER
Follow procedure described in =INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See
=PRODUCT SPECIFICATIONS" on page 3 ofthis manual).
If tires are over or underinflatad, you will not properly adjust
your mower.
SUSPENSION ADJUSTMENT
ARMS LIFT
LINKS
SIDE-TO-SIDE ADJUSTMENT (See Figs. 18 and 19)
• Raise mower to its highest position.
• Measure height from bottom of deck curl to ground
level at front comers of mower. Distance "A" on both
sides of mower should be the same.
• If adjustment is necessary, make adjustment on one
side of mower only.
• To raise one side of mower, tighten lift link adjustment
nut on that side.
• To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Each full turn of adjustment nut will change mower
height about 3/16".
[ seRl"reOt'Meck measure m ents after adjusting" BOTTOM ]OF A'_-"_'''"_C__CURL' GROUND UNE _''"_" "_-
FIG. 19
FRONT
SUSPENSION
CHASSIS
ELECTRIC
CLUTCH
PULLEY
" FRONT
SUSPENSION
BRACKET
RETAINER
SPRING
ANTI-SWAY
BAR
RETAINER
SPRINGS
RETAINER
FRONT MOWER
BRACKET
FIG. 18
2O