Specifications; Model Numbers; Systems - Exmark TURF TRACER S-SERIES Operator's Manual

Specifications

Specifications

Model Numbers

Serial Nos: 920,000 and Higher
Manual Start Models: TTS16KA363; TTS16KA363CA; TTS16KA483; TTS16KA483CA; TTS18KA523
Electric Start Models: TTS20KAE483; TTS20KAE483CA; TTS20KAE523

Systems

Engine
• Engine Specifications: See your Engine Owner's
Manual
• Engine Oil Type: Exmark 4–Cycle Premium
Engine Oil
• RPM: Full Speed: 3600 (No Load)
Idle: 1550 RPM
Fuel System
• Capacity: 5.0 gal. (18.9 L)
• Type of Fuel: Regular unleaded gasoline, 87
octane or higher; containing no more than 10%
methanol or ethanol.
• Fuel Filter: Replaceable In-line
• Fuel Shut-Off Valve: 1/4 turn increments
Electrical System (Electric Start)
• Charging System: Flywheel Alternator
• Charging Capacity: 15 amps
• Battery Type: BCI Group U1
• Battery Voltage: 12 Volt
• Polarity: Negative Ground
• Fuses: Two 20 amp blade type
Safety Interlock System:
• Operator must have OPC (Operator Presence
Control) levers held in contact with handle
grips, speed control lever in neutral, and PTO
disengaged to start engine. Release of OPC levers
will cause the engine to stop if speed control lever
is not in neutral and/or PTO is engaged.
• Park brake must be disengaged to move speed
control out of neutral or engine will kill.
Operator Controls
Steering Control: Fingertip drive control levers
provide independent speed control, braking and
neutral to each drive wheel for moving forward or
reverse, stopping, and power turning.
Transmission
Twin Hydrostatic Drive
• Two Hydro Gear variable displacement high
efficiency pumps independently coupled to two
high efficiency Parker/Ross wheel drive motors.
• Hydraulic Oil: Use Exmark Premium Hydro Oil.
• Hydraulic Oil Capacity: 2.4 qt. (2.2 L)
• Hydraulic Filter is replaceable cartridge type.
P/N 109-4180: 25 microns, 10 psi bypass
(Summer use above 32°F (0°C))
P/N 1-523541: 40 microns, 18 psi bypass (Winter
use below 32°F (0°C))
• Speeds:
– 0-6.2 mph (10.0 km/hr) forward.
– 0-2.2 mph (3.5 km/hr) reverse.
• Drive wheels release valves allow machine to be
moved when engine is not running.
Wheel Drive System
Drive wheels are direct coupled to Parker wheel drive
motors with 1 inch (25.4 mm) tapered shaft.
14