Using The Grass Bag - Exmark METRO 21 Operator's Manual

Operation
WARNING
Adjusting the cutting height levers could
bring your hands into contact with a moving
blade. A moving blade can cause serious
injury.
• Stop the engine and wait for all movement
to stop before adjusting the cutting
height.
• Do Not put your fingers under the
housing when adjusting the cutting
height.
1. Pull the wheel height adjustment lever toward
the wheel (Figure 13) and move it to the desired
setting.
Figure 13
1. Pull towards wheel
2. Wheel Height
Adjustment Lever
2. Release the wheel height adjustment lever and set
it securely in the notch.
3. Adjust all the wheels to the same cutting height
setting.

Using the Grass Bag

Occasionally, you may wish to use the grass bag for
bagging extra long grass, lush grass, or leaves.
• Installing the Grass Bag
1. Stop the engine and wait for all moving parts
to stop.
2. Ensure that the discharge door handle is fully
forward and that the pin is engaged in the
catch (Figure 14).
3. Notches
1. Bag Frame on retaining
post.
2. Pin engaged in catch.
3. Slide the hole in the bag frame onto the
retaining post on the discharge tunnel.
4. Set the rear of the bag frame onto the bag
support rod.
5. Pull the discharge door handle forward until
the pin clears the catch, and move the handle
rearward until the pin locks in the bag notch
(Figure 15).
1. Pin locked in bag notch.
Note: The discharge door in the lawn mower
housing is now open.
20
Figure 14
3. Handle fully
forward—discharge
door closed.
Figure 15