Eureka 790 Series Owner's Manual page 6

HOW TO USE
CORD
3
RETAINER
HANDLE
4
COLLAPSE
BUTTON
CORD
5
STORAGE
HOOKS
HANDLE
6
RELEASE
PEDAL
RESET
7
BUTTON
RESET
8
LIGHT
REMOVABLE
9
EXHAUST GRILLE
6
Handle Release Pedal
The handle release pedal is located next to the floor between
the two wheels on the back of the cleaner. Step on the handle
release pedal and pull back handle to find a comfortable
operating position. Handle will automatically lock into storage
position when handle is rotated into upright position.
7
Reset Button
This unit uses a cogged, non-stretch belt. If a large object causes
the brush roll to jam, the brush roll motor shuts off and the Reset
Light illuminates. Turn off and unplug the unit. Check the brush roll
for debris and clean if needed. Press the reset button, plug in the
unit and turn on to continue cleaning.
8
Reset Light
The reset light is a neon light that illuminates when the brush roll
jams. See reset button above for actions to take when this light comes
on.
9
Removable Exhaust Grille
Remove this exhaust grille to clean or replace filter. Refer to page 9.
6
3
Cord Retainer
When preparing to use vacuum,
firmly push the electrical cord
down into the cord retainer. This
will place the electrical cord out
of the way while you vacuum.
4
Handle Collapse Button
To collapse the handle from the
upright position, press handle
collapse button, rotate handle
down until latch in hand grip
locks onto the body.
5
Cord Storage Hooks
This unit has two convenient
cord storage hooks attached
to the handle. Wind the cord
around the hooks and fasten
the plug to the cord to prevent
unwinding.