LG 42LB1DRA - 42" LCD Integrated HDTV Service Manual page 15

10. ADC-Set Adjustment
10-1. Synopsis
ADC-Set adjustment to set the black level and the Gain to
optimum.
10-2. Test Equipment
Service R/C, 801GF(802B, 802F, 802R) or MSPG925FA
Pattern Generator
(720P The Horizontal 100% Color Bar Pattern output will be
possible and the output level will accurately have to be
revised with 0.7±0.1Vp-p)
<Fig. 3> Adjustment Pattern : 480i/1080i 60Hz HozTV31
Bar Pattern
10-3. Adjustment
(1) ADC 480i Component1 Adjustment
Check the connection Component1 to the Test Equipment
(1) Select Component1 as the input with 100% Horizontal
Color Bar Pattern(HozTV31Bar) in 480i Mode and
select 'Normal' in screen.
(2) After receiving signal for at least 1 second, press the
ADJ Key on the Service R/C to enter the 'Ez - Adjust'
and select the '4. ADC 480i Comp1'.
Pressing the Enter Key to adjust with automatic
movement.
(3) When the adjustment is over, 'ADC Component1
Success' is displayed.
(4) If the adjustment has errors, 'ADC Configuration Error'
is displayed. And error massage('Component Not
Connection' or 'Change Format to 480i' or 'Check
Pattern of device' ) is displayed for 1 second.
(2) ADC 1080i Component2/RGB Adjustment
Check the connection Component2, RGB to the Test
Equipment
(1) Select Component2 as the input with 100% Horizontal
Color Bar Pattern(HozTV31Bar) in 1080i Mode and
select 'Normal' in screen.
(2) After receiving signal for at least 1 second, press the
ADJ Key on the Service R/C to enter the 'Ez - Adjust'
and select the '5. ADC 480p Comp2/RGB'.
Pressing the Enter Key to adjust with automatic
movement.
(3) When the adjustment is over, 'ADC Component2
Success' is displayed. If the adjustment has errors,
'ADC Configuration Error' is displayed.
(4) After the Component2 adjustment is over, convert the
RGB-DTV Mode and display Pattern.
When the adjustment is over, 'ADC RGB_DTV Success'
is displayed.
(5) Readjust after confirming the case Pattern or
adjustment condition where the adjustment errors.
Error massage is 'Component Not Connection' or
'Change Format to 480i' or 'Check Pattern of device'.
(6) After adjustment is complete, exit the adjustment mode
by pressing the ADJ KEY.
11. Adjustment of White Balance
11-1. Connection Diagram of Equipment
for Measuring
Full White Pattern
<Fig. 4> Connection Diagram of Automatic Adjustment
[ RS-232C Command
RS-232C COMMAND
[CMD ID DATA]
Cool Mid
R Gain Jg Ja
G Gain Jh Jb
B Gain Ji Jc
R Cut
G Cut
B Cut
- 15 -
(Automatic Adjustment)
COLOR
ANALYZER
TYPE; CA-100
Digital RGB
PDP MONITOR
MSPG-925FA
(Automatic Adjustment)
CENTER
(DEFAULT)
Min
Warm Cool Mid
Jd 00 184 161
Je 00 187 183
Jf 00 192 192
64 64
64 64
64 64
Max
Warm
192 255
159 255
95 255
64 127
64 127
64 127