Basic Tools And Materials - Craftsman 390.291558 Owner's Manual

CONTENTS
WARRAN'I_' ................................................... 2
SAFETY ............................................................................ 2
INSTAI+I+ATION........................................................... 3-6
()IWRATION .................................................................... 7
SERVI('E HINTS ............................................................ 7-9
REPAIR PARTS ........................................................... lfl-l 1
INTRODUCTION
Please read our instructions before yon install and use your
tank. This will help you obtain full benefits ti'om this tank.
It will also help you avoid needless service expense that
resuh from
catlses we cannot control aild cannot cover in
our \¥a rrailt y+
BASIC TOOLS AND MATERIALS NEEDED
PLASTIC PIPE INSTALLATIONS
TOOLS MATERIALS
Pipe Wrenches Plastic Pipe and Fittings (as required to complete job).
Screwdriver Teflon Tape (DO NOT use pipe joint compound on
Knife or Saw to Cut Plastic Pipe plastic fittings) or Plasto-Joint Stik*
Tire Pressure Gauge
GALVANIZED STEEL PIPE INSTALLATIONS
TOOLS
Pipe Wrenches
Screwdrivers
Pipe Cutting and Threading Tools
Tire Pressure Gauge
HATERIALS
Galvanized Pipe and Fittings (as required to complete job).
Pipe Joint Compound or Teflon tape
INSTALLATION
+_WARNINt If your system can develop more than 100
Hazardous PSI pressure, install a Sears No. 2729 relief
pressure
valve in system to prevent possibility of
tank blow-up.
NOTICE: DO NOT use any type of lubricant other than
water on Hose to Plastic fittings.
ff rigid piping is installed to elbow on inlet flange, BE SURE
to support the piping.
For proper installation of your pump to tank, follow one
of the typical installations on Page 4 and 5. Use Teflon tape
on all threaded connections to tank.
Standard pipe fittings, such as nipples, tees and elbows
must be purchased locally. If you are using a horizontal jet
pump mounted on top of tank, Figures 5 and 6, Kit No.
2788 is required. See Page 10 for contents of kit.
If your present system has an air volume control (AVC), re-
move it and plug AVC port on pump.
Complete pump, tank, and piping system MUST be pro-
tected against below freezing temperature. Failure to do
so could cause severe damage and voids the warranty.
* Lake Chemical Co., Chicago, Illinois.