Gas Supply; Safety Information - Coleman 035-16329-002 Owner's Manual

035-16329-002 Rev. B (0304)
C onBratuL_tion_...
On your purchase of one of the most versatile furnaces available in the industry today. This compact, energy-efficient furnace
has been precision designed, manufactured of high-quality materials and has passed many rigorous inspections and tests to
ensure many years of satisfactory service. This booklet is meant to increase your understanding of your unit, tell you how to
operate it e_ciently and how to obtain the greatest measure of comfort at the lowest operating expense. Please read this book-
let thoroughly. We appreciate your interest in our product and your decision to purchase our furnace. Enjoy your comfort.
INTRODUCTION
WARRANTY AND
RESPONSIBILITIES
It is the sole responsibility of the
home owner to make certain that
the gas furnace has been correctly
set up and converted to the proper
fuel (Propane or Natural gas) and
adjusted to operate properly.
The manufacturer warrants the fur-
nace to be free from defects in
material or workmanship for the
stated time in the warranty agree-
ment (see warranty certificate
packed with the furnace).
However, the manufacturerwill not
be responsiblefor any repair costs
to correct problems due to
improper set-up, improper installa-
tion, furnace adjustments, improper
operating procedure by the user,
etc.
Some specific examples of service
calls which cannot be included in
warranty payments are:
1. Converting the furnace to use
another type of gas.
2. Correcting faulty duct work in
the home.
3. Correcting wiring problems in
the electrical circuit to the fur-
nace.
4. Resetting circuit breakers or
other switches.
5. Adjusting the burner air shut-
ter or service calls made to cor-
rect problems caused by
improper air adjustment.
6. Correctingproblemscaused by
improper gas supply pressure
to the furnace.
7. Instructionaltraining on how to
light and operate furnace.
8. Furnace problemscaused by
installationof air conditioner,
heat pump, or other air quality
device which is not approved.
9. Problems caused by improper
installationof the furnace flue
assembly (roofjack).
10. Adding a roofjack extension
because of unusualwind con-
ditions or snow conditions.
11. Adjusting or calibrating the
thermostat.
12. Problems caused by construc-
tiondebds which has fallen into
the flue or combustion air
openings.
13. Replacement of fuses.
14. Problems caused by odfice
plugged or restricted by spider
webs.
You should establish a firm under-
standing of these responsibilities
with your manufactured housing
dealer, service company or gas
supplier so there will be no misun-
derstanding at a later time.
GAS SUPPLY
The gas supply to your home will
either be Natural Gas or Propane
gas. Your furnace will be factory
equipped to operate on only one of
these two differentgases.
A small metal tag secured to the
fumace next to the gas valve will
specify the type of gas your fur-
nace is equipped to use.
If the gas is different from that
specified on the metal tag, the fur-
nace can be converted by following
the instructions on the furnace
safety label inside lower front
panel. Parts for conversion are
contained in the small bag attached
to the gas valve. Be sure the
proper size odfice is used, as spec-
ified on the furnace name plate.
IA CAUTION j
The furnace must be
converted by a qualified
technician. Improper
conversion can cause
unsafe operation, explo-
sion, and/or fire or
asphyxiation.
Natural Gas Operation
The fumece is designed for 7" W.C.
inlet pressure. Pressure is reduced
to 3 1/2" W.C. by the pressure reg-
ulator in the gas valve.
Propane Gas Operation
Inlet pressure to the gas valve
must be 11" W.C. When properly
converted to Propane gas, the
pressure is regulated at 10" W.C.
SAFETY INFORMATION
For your safety read before light-
ing.
1. The first lightingof the furnace
after any home setup must be
performed by a qualified ser-
vice technician.
2.
3.
If this appliance has a pilotthat
must be lit by hand, follow
these instructionsexactly.
BEFORE LIGHTING smell all
around the furnace for gas. Be
sure to smell next to the floor
because some gas is heavier
than air and will settle on the
floor.
2 Unitary Products Group