Sony HT-CT660 Operating Instructions Manual page 33

 Change the Wi-Fi frequency of the
Wi-Fi router, computer, etc., to
5 GHz band.
OTHERS
The remote control does not
function.
 Point the remote control at the
remote control sensor
system.
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the
remote control with new ones, if
they are weak.
 Make sure you select the correct
input on the remote control.
The Control for HDMI function does
not work properly.
 Check the HDMI connection
(page 14).
 Set up the Control for HDMI function
on the TV.
 Make sure the connected
equipment is compatible with
"BRAVIA" Sync.
 Check the Control for HDMI settings
on the connected equipment. Refer
to the operating instructions
supplied with the connected
equipment.
 If you connect/disconnect the AC
power cord (mains lead), wait for
more than 15 seconds and operate
the system.
 If you connect the audio output of
the video equipment and the
system using other than an HDMI
cable, no sound may be output
because of "BRAVIA" Sync. In this
case, set the "CTRL" to "OFF"
(page 28) or connect the audio
output jack directly to the TV instead
of the system.
"PROTECT" appears on the front
panel display.
 Press  to turn off the system.
After "STBY" disappears, disconnect
the AC power cord (mains lead),
then check that nothing is blocking
the ventilation holes of the system.
RESET
on the
If the system still does not operate
properly, reset the system as follows:
1
Press  to turn on the Sound
Bar.
2
Press  while pressing INPUT
and VOL  on the Sound Bar.
3
When "RESET" appears on the
front panel display, release the
buttons.
4
Disconnect the AC power cord
(mains lead).
AMP menu, sound field, etc.,
return to the default settings.
33
US