Advertisement
After installing your air condilioner, plug it into the proper
electrical ouzel in the wall.
POWER
Turns air conditioner
off.
SPEED "LOW"
Low speed fan operation
with cooling
or not.
SPEED "HI"
High speed fan operation
with cooling
or not,
This automatically
controls the
temperature
of indoor
air. Turn
the knob
so that arrow points to the cooler marks for more moderate
cooling.
Normal
Fan
1. Turn the SPEED mode switch to the "HI' or the "LOW' setting.
2. Set the thermostat
control
to tile temperature
mark "FAN ONLY'.
Normal
cooling
1. Turn the SPEED mode switch to the "HI' or the "LOW' setting,
2. Set the thermostat
control
to tile desire temperature
(the mid-point
is a good
garfing
position).
If the room temperature
is not satislractory after a reasonable
time,
adjust
Ihe conlrol
Io a
wormer
soiling, os approprialc.
Maximum
cooling
1. Turn the ,SPEED mode _witch to the "1I1' seffing
2. Set the thermostat
control
to the MAX COOL
temperature
mark.
Quieter
operation
1. Turn the ,SPEED nqode switch to the "LOW'
seffing.
2. Set the thermostat
control
as needed.
CAUTION:
" ) Remember
the compressor of your air conditioner will not work
when the temperature goes below 65_F.
) Also when you shut off the air conditioner
wait for 3 minutes
before turning
it on again. This is the compressorcycle time.
2} If you have any trouble in operating your air conditioner please refer to
the Trouble Shootlng section.
13
Advertisement
