Step 5: Performing The Easy Setup; Calibration - Sony BDV-N8100W Operating Instructions Manual

Step 5: Performing the
Easy Setup
Before performing Step 5
Follow the Steps below to make the basic
adjustments and network settings for the
system.
Displayed items vary depending on the
area.
1
Insert two R03 (AAA) batteries
(supplied) by matching the 3
and # ends on the batteries to
the markings inside the
compartment.
2
Turn on the TV.
3
Connect the calibration mic to
the A.CAL MIC jack on the rear
panel.
Set up the calibration mic at ear level
using a tripod, etc. (not supplied). The
calibration mic should aim the TV
screen. The front of each speaker
should face the calibration mic, and
there should be no obstruction between
the speakers and the calibration mic.
4
Press [/1 to turn on the system.
5
Switch the input selector on
your TV so that the signal from
the system appears on the TV
screen.
The [Easy Initial Settings] for OSD
language selection appears.
6
Perform [Easy Initial Settings].
Follow the on-screen
instructions to make the basic
settings using B/V/v/b and
For details about [Auto Calibration],
see "Calibrating the Appropriate
Speaker Settings Automatically"
(page 50).
7
After completing the [Easy Initial
Settings], press V/v to select
[Easy Network Settings], then
press .
The [Easy Network Settings] display
appears.
8
Follow the on-screen
instructions to make the network
settings using B/V/v/b and
If the system cannot connect to the
network, see "Network connection"
(page 75) or "Wireless LAN
connection" (page 75).
.
B/V/v/b
.
US
31