Enerco HEATSTAR HS4040 Operating Instructions And Owner's Manual

Installer: Leave this manual with the appliance. Consumer: Retain this manual for future reference.
Operating instructiOns and Owner's Manual
Heatstar High-intensity infrared Heaters
HS4040 HS9100S
HS8060 HS9120
4000 & 8000 Models
warning:
if the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
— WHAT To Do IF YoU SMell GAS
• Shut off gas supply
• Do not try to light appliance
• Do not touch an electrical switch; do not use any phone in your building
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions
• If you cannot reach your gas supplier, call the fire department
— Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
This is an unvented gas-fired heater. It uses air (oxygen) from the area in which it is used. Adequate
combustion and ventilation air must be provided. Refer to page 4.
read instructiOns careFullY: Read and follow all
instructions. Place instructions in a safe place for future
reference. Do not allow anyone who has not read these
instructions to assemble, light, adjust or operate the heater.
ENERCO GROUP INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 216-916-3000
9000 Models
18650 Rev. A 06/08