Table of Contents
Advertisement
Item
ECO MODE
MIRROR
STANDBY MODE
MONITOR OUT
Using the
▲/▼
buttons changes the eco mode setting.
NORMAL ó ECO
• When the ECO is selected, acoustic noise and screen brightness
are reduced.
Using the ▲/▼ buttons switches the mode for mirror status.
NORMAL ó H:INVERT ó V:INVERT ó H&V:INVERT
If the Transition Detector is on and MIRROR status is changed,
TRANSITION DETECTOR ON alarm (55) will be displayed when
projector is restarted after the AC power is turned off.
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL ó SAVING
• When SAVING is selected and the projector is in the standby
state, the power consumption is lowered with some functional
restrictions as below.
- The RS-232C communication control is disabled except turning
the projector on and changing the STANDBY MODE setting.
- The STANDBY of the MONITOR OUT (below) is invalid, and no
signal is output from the MONITOR OUT port.
- The AUDIO OUT STANDBY of the AUDIO SOURCE (40) is
invalid, and no signal is output from the AUDIO OUT ports (5).
While the image signal from the input port chosen in step (1) is
projected, the image signal from the input port selected in step (2)
is output to MONITOR OUT port.
(1) Choose a picture input port using
▲/▼ buttons.
Choose STANDBY to select the
picture output in the standby mode.
(2) Select the output signal from the
MONITOR OUT port using ◄/►
buttons.
Select OFF to disable the MONITOR
OUT port for the input port or standby
mode chosen in the step (1).
• If you have changed the setting of STANDBY, it applies only to
the current standby mode, NORMAL or SAVING, selected under
STANDBY MODE, without changing the setting of the other mode.
The factory settings are as follows:
- COMPUTER IN for the NORMAL mode of STANDBY MODE
- OFF for the SAVING mode of STANDBY MODE
Description
SETUP menu
39
Advertisement
Table of Contents
