HP Designjet L65500 User Manual page 12

15. Once in front of the printer, if you find that you haven't unrolled enough substrate, select Start
main roller motion from the front panel's Substrate menu
substrate unrolls only when you pull it.
16. Before taping the leading edges of the two substrate rolls to the empty cores on the output
spindle, check by measurement that they are in the same positions on the output spindle as on
the input spindle.
17. Tape the leading edges of both rolls to the empty cores on the output spindle.
18. Ensure that the four edge holders are correctly positioned, leaving the substrate free to move.
19. Unlock the differentials on the input and output spindles.
20.
Go to the front panel and select the Substrate menu
press OK. Select Carriage beam position > Move to printing (normal) to lower the carriage
beam into its normal position, close to the substrate. This process takes about 2 minutes to
complete.
8 Chapter 2 Use of the dual-roll spindle
to unroll some more. The
, then Substrate management, and
ENWW