Table of Contents
Advertisement
Before you Begin
Quick Connect II™ Set-up for the R800 & R1800
For more detailed instructions please refer to the Video Installation Guide on your PowerDriverSupra 1800
1. Check to ensure that you have all of the components necessary to setup your Quick Connect
II™ system.
Components
1. Ink Cartridge + tubes
2. 1 x Long Tube Grip
3. 1 x Short Tube Grip
4. Chips
5. 8x Ink Bags
6. Small primer bottle
7. Cartridge Cover (R1800 Only)
8. Cartridge placement sticker
9. Rubber Gloves
10. Ink Box
11. Foam Block for R800 only
12. Power Driver CD
2. Place the Quick Connect II box on a level surface next to where
your printer is going to be placed. For the R800 it should be on the
left hand side of the printer with the clamps facing towards the
back. For the R1800 it should be on the right hand side with the
clamps facing towards the front.
Your ink bags should never be elevated above
the print head. Keeping the bags beside the
printer at the same level assures the ink delivery
system will operate properly.
3. Remove the lid from the box and place it to the side.
It is crucial that the OEM ink supplied with your
printer is installed before you attempt to install
your SubliJet IQ™ inks. This allows for two things:
First, it primes the ink delivery system, ensuring
that the SubliJet IQ™ ink will load more easily.
Second, it familiarizes you with the basic operation
of your printer. Please see the EPSON Stylus
Photo R800 or R1800 Printer User's Guide for
instructions on installation.
(Not Shown)
(Not Shown)
Advertisement
Table of Contents
