Advertisement
Available languages
Available languages
Cleaning the
appliance
To avoid electrical shock which
can cause death or severe
personal
injury, disconnect
power
to appliance
before cleaning.
After cleaning,
reconnect
power.
To avoid personal
injuries or
property
damage, observe the
following:
Do not clean the appliance
with
a steam cleaner.
Do not let the water used for
cleaning
drip onto the light or
control
panel.
Do not use abrasive or acidic
cleaning
agents or solvents
which may damage the
surfaces of the appliance.
Never clean shelves and
containers
in the dishwasher.
The parts may warp.
C3 Switch
off the appliance
with
the on/off
button!
Pull out the mains
plug or
switch
off the fuse.
C3 Clean the door seat with water
only and dry thoroughly.
C3 Clean the appliance
with
lukewarm
water and a little
dishwashing
liquid.
Do not let the water used for
cleaning
drip onto the control
panel or light.
C3 Checkthe
ventilation
openings
on the base panel. Remove dirt
with a vacuum cleaner.
After cleaning:
C3 Reinsert the mains plug or
switch on the fuse. Switch on
the appliance
with the on/off
button.
Have your supplier inform you
about special cleaning and care
information
for appliance
surfaces.
C3 Wipe appliance
surfaces with
a damp cloth.
Then immediately
wipe dry.
Odors
If the appliance
is emitting
unpleasant
odors:
[3
Switch
off the appliance
with
the on/off
button!
C3 Clean the interior.
See section on "Cleaning the
appliance".
C3 Checkthe
odor filter.
See section on "Changing
the
filter".
C3 Thoroughly
clean all packing
containers
used in the
appliance.
C3 Switch on the appliance
again
with the on/off
button.
C3 After 24 hours check whether
the odors have been eliminated.
Warning
messages
via the display
If several warning messages
are
displayed
simultaneously,
deal with
each message
individually.
While a warning
message is
displayed,
buttons
cannot be
pressed.
Door alarm
Cause
An appliance
door has not been
closed properly or has been
open too tong.
Remedial
action
C3 Ctosethe
door.
The display goes out.
Sensor fault
Cause
A technical
defect is possible.
E01 - defect in the top
compartment
E02 - defect in the bottom
compartment
Remedial
action
C3 Conduct
an appliance
self test.
15
Advertisement
Chapters
