Connections To The Ethernet Port On The Cpu/System Controller Board; Standard 10/100Base-T Ethernet Cable (Cpu Module To Hub) - Emerson ControlWave EFM 3808 Instruction Manual

2.3.7 Connections to the Ethernet Port on the CPU/System
Controller Board
Caution
Figure 2-11. Standard 10/100Base-T Ethernet Cable (CPU Module to Hub)
Revised Mar-2011
ControlWave Express Instruction Manual (CI-ControlWave Express)
The RJ45 Ethernet port is connector (J1) located on the CPU/System
Controller board. The board also has one RJ45 port (J2) for the optional
Display/Keypad. Never connect Ethernet to J2 (the Display/Keypad port)
or damage will result.
The 33MHz ControlWave Express can support one Ethernet port. This
port uses a 10/100Base-T RJ-45 modular connector (J1) that provides a
shielded twisted pair interface to an Ethernet hub.
A typical Ethernet hub provides eight 10/100Base-T RJ-45 ports (with
port 8 having the capability to link either to another hub or to an
Ethernet communications port). Both ends of the Ethernet twisted pair
cable are equipped with modular RJ-45 connectors.
Figure 2-10. RJ-45 Ethernet Connector
These cables have a one-to-one wiring configuration as shown in
Figure 2-11. Table 2-11 provides the assignment and definitions of the
8-pin 10/100Base-T connectors.
Table 2-11. Ethernet 10/100Base-T CPU Module Pin Assignments
Pin
1 Transmit Data+ (Output)
2 Transmit Data– (Output)
3 Receive Data+ (Input)
4 Not connected
5 Not connected
6 Receive Data– (Input)
Installation
1 8
Looking into
receptacle
Description
2-21