Connections
Connecting your X-Ref Series speakers to a power amp or receiver
Although the X-Ref Series speakers have no special connection requirements, the following
suggestions may be helpful:
•
Always use high-quality speaker wire of reasonable gauge (16 gauge or heavier)
•
If you must use thinner wire, try to keep the length as short as possible
•
Be careful to wire both (or all) speakers "in phase" (the plus/red terminal on each
speaker to the plus/red terminal on your amp)
•
Try to use wires of equal length and gauge for symmetrical pairs of speakers
(don't use a long 16 gauge wire for your Left Front and a short 10 gauge wire
for the Right Front)
•
If you use stranded cables, use care to avoid short circuits (from stray strands touching)
•
Emotiva offers very high quality pre-made speaker cables at reasonable prices
(you will find them in the Interconnects section of our website at www.emotiva.com)
X-Ref Series terminal plate
(on rear panel) -
showing bi-amp terminal links
(REMOVE these links for
bi-wiring or bi-amping)
Various types of common speaker connections (one channel shown)
Standard Speaker
Bi-Wired Speaker
Connection
AMPLIFIER
SPEAKER
Bi-amp terminal
Bi-amp terminal
links CONNECTED
links REMOVED
Page 16
Passive Bi-Amped Speaker
Connection
AMPLIFIER
AMPLIFIER 1
SPEAKER
Bi-amp terminal
links REMOVED
Connection
Both ampli er inputs
are connected to the
same preamp output
signal
SPEAKER
AMPLIFIER 2