Electrolux EHD68200P User Manual page 30

30 electrolux what to do if ...
Problem
flashes
is lit
and number are displayed Electronics fault
If you are unable to remedy the
problem by following the above
suggestions, please contact your
dealer or the Customer Care De-
partment.
Warning! Repairs to the appliance
are only to be carried out by quali-
fied service engineers. Considera-
ble danger to the user may result
from improper repairs.
If the appliance has been wrongly
operated, the visit from the custom-
er service technician or dealer may
not take place free of charge, even
during the warranty period.
Possible cause
Unsuitable cookware
No cookware on the cooking
zone
Diameter of the base of the
cookware is too small for the
cooking zone
Cookware not completely cov-
ering cross
Overheating protection for the
cooking zone has been trig-
gered
Safety cut-out has been trig-
gered
Remedy
Use suitable cookware
Put cookware on zone
Use suitable cookware (min.
120 mm)
Place cookware centrally over
the cross
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the
customer service department