Electrolux EFP 60202 User Manual page 71

Fitting the charcoal filter for r Fitting the char Fitting the char Fitting the char Fitting the char coal filter for r coal filter for r coal filter for recir coal filter for r
If the extractor hood is installed as a return air appliance (Recirculation version -
air outlet above the wall unit), the charcoal filter (available from your local Service
Force Centre) must be fitted before the grease filters are fitted.
Installation sequence: Installation sequence: Installation sequence:
Installation sequence: Installation sequence:
1. Insert the holding frame for the charcoal filter in the shaft of the hood with the
2 lugs facing upwards and then clip into the lower holes.
2. Fix the holding frame on the lower part of the housing of the hood with the 2
screws supplied.
3. Fit the charcoal filter (see paragraph "Charcoal filter")
4. Refit the grease filters. Push-in the visor.
Removing the hood fr Removing the hood from the wall unit Removing the hood fr
Removing the hood fr Removing the hood fr
If, for technical reasons (extraction version/recirculation version conversion) the
extractor hood has to be removed from the wall unit, proceed as follows:
• Fully withdraw the visor and remove the grease filter.
• Loosen the 4 or 6 mounting screws of the hood (wall unit mounting).
• To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips
screw-driver in the spring opening and simultaneously press the springs
inwards (towards the appliance housing).
Important: Hold the hood firmly! Important: Hold the hood firmly!
Important: Hold the hood firmly! Important: Hold the hood firmly! Important: Hold the hood firmly!
ecir ecirculation version ecir ecir culation version culation version culation version culation version
om the wall unit om the wall unit om the wall unit
om the wall unit
electrolux electrolux installation electrolux
electrolux electrolux
71 71 71
71 71
GB