Electrolux EFP 60202 User Manual page 70

70 70 70 70 70 electr electr electrolux electr electr olux olux olux installation olux
• For 16 mm side walls, the spacer discs clipped in on the appliance body must
be taken out. Mount the hood with 4 or 6 x Ø 4 mm screws.
• Insert the hood in the furniture housing and engage both mounting claws
(installation aids) (installation aids)
(installation aids) (installation aids) on the right and left sides in the side wall of the wall unit and (installation aids)
firmly hold the hood for further mounting.
Then fix the hood with the 4 or 6 x Ø 4 mm screws supplied.
• Refit the grease filters. Push-in the visor.
• If the cupboard is deeper than 300 mm, cover the gap between the hood and
the wall with a finishing strip (special accessory).
To install it, proceed as follows:
Measure the wall distance and apply the covenng strip over the necessary
width (wall distance plus 5 to 8 mm), kinking the covering strip at the
appropriate notches and tearing off the surplus material (removing the
protective foil).
Then fasten the strip to the bottom part of the hood with three clips (special
accessories).
Apply pressure.
GB