• A qualified and competent person must do the – if the control panel, worktop or plinth area are electrical installation. damaged so that you can get access to the in- ner side of the appliance. • A qualified and competent person must do the Contact your local Customer Care Centre.
Washing programmes Program Degree of soil Type of load Program description Pots Heavy soil Crockery, cutlery, Prewash pots and pans Main wash up to 70°C 2 intermediate rinses Final rinse Drying Regular Plus Normal soil Crockery and cutlery Prewash Main wash up to 65°C 2 intermediate rinses Final rinse Drying...
3. Set the correct washing program for the type of 5. Start the washing program. load and soil. 4. Fill the detergent dispenser with the correct quantity of detergent. Use of rinse aid Caution! Only use rinse aid specified for Fill when the rinse aid in- dishwashers.
Page 6
– Make sure that glasses do not touch other glasses. – Put small objects in the cutlery basket. • Plastic items and pans with non-stick coatings can retain water droplets. Plastic items do not dry as well as porcelain and steel items. •...
Caution! If the basket is in the upper position, do not put cups on the cup racks. Use of detergent Only use detergents (powder, liquid or tablet) that are suitable for dishwashers. Follow the data on the packaging: • dosage recommended by the manufacturer, •...
2. Close the appliance door. The washing program When the washing program operates, you can- continues from the point of interruption. not change the program. Cancel the washing program. End of the washing program Warning! Only interrupt or cancel a washing •...
Long periods of non-operation Do these steps when you do not use the appliance for a long period: 1. Disconnect the mains plug from the mains sock- 2. Close the water tap. 3. Keep the door open to prevent unpleasant smells.
Page 10
Fault code and malfunction Possible cause and solution • continuous flash of the start/cancel • The water tap is blocked or furred with limescale. indicator light Clean the water tap. • 1 flash of the 'Finished' indicator • The water tap is closed. light Open the water tap.
The cleaning results are not satisfactory There are streaks, milky spots • Decrease the rinse aid dosage. or a bluish coating on glasses and dishes Dry water drop stains on • Increase rinse aid dosage. glasses and dishes • The detergent can be the cause. Technical data Dimensions Width (mm)
These must be purchased The water pressure must be in the limits (refer to from Electrolux Spare Parts. The extension length 'Technical data'). Make sure that the local water au- must not exceed 2 metres.
Australia and Electro- This document sets out the terms and conditions lux (NZ) Limited in respect of Appliances pur- of product warranties for Electrolux branded ap- chased in New Zealand; pliances. It is an important document. Please –...
Page 14
Where you are within an Electrolux service area, as contained in this document; this warranty covers the cost of transport of the – Electrolux shall not be liable for any loss or Appliance to and from Authorised Service Cen- damage whether direct or indirect or conse-...
Page 15
– in the case of Appliances, at its option, to the its Authorised Service Centres to exchange informa- replacement or repair of the Appliances or the tion in relation to you to enable Electrolux to meet its supply of equivalent products or the payment obligations under this warranty.