EarthQuake 9050300 Operator's Manual page 12

ATTACHINg HOPPeR exTeNSION TO HOPPeR
For european models only (9050140, 9060140, and
9010140)
Tools Required:
hopper extension
5/32" Hex drive wrench (i.e: allen wrench)
7/16" Wrench for 1/4-20 flange nut
NOTe: Assemble extension before adding fuel or engine oil.
To attach the hopper extension:
1) Before bolting the handle into position, slide one hopper ex-
tension half (1709470) over the rim of the hopper. The groove
1/4-20 bolt
around the inside bottom of the hopper extension should fit
BALLOON #
P A R T #
over the rim around the top of the hopper. See FIgURe 22.
1 1 9 6 0 5 0 7
2) Ensuring the hopper and hopper extension holes are now
2 1930642
aligned along the top rim of the hopper, place a 1/4-20 x 3/4
3 1 7 0 9 4 7 0
bolts (1960507) through each of the four holes in the extension
and hopper. Secure bolts in place with the included 17/64 x 5/8
flat washers (1921319) and 1/4-20 flange nuts (1930642). DO
NOT fully tighten hardware at this point. See FIgURe 22.
3) Bolt handle into position using appropriate hardware. Lay the
unit down, resting the handle on a piece of cardboard to pre-
vent scratching.
4) Follow Step 1 to install the second extension half to the opposite
side of the hopper. Again, the bottom groove of the hopper
extension should fit over the rim at the top of the hopper. Align
the bolt holes between the top of the hopper and bottom of the
hopper extension and insert hardware. See FIgURe 23.
5) Place a 1/4-20 x 3/4 bolt (1960507) in each of the three holes
along the two seams of the joined hopper extension halves.
Secure each bolt with a flat washer and flange nut. DO NOT
fully tighten. See FIgURe 24.
6) Place bolt through each of the two holes on top of the joined hopper
extension. Secure with flat washer and flange nut. See FIgURe 25.
7) Once all hardware has been inserted, use 5/32" allen wrench and
7/16" wrench to fully tighten all hardware, including those around
hopper rim and along the hopper extension seams.
hopper extension
1/4-20 bolt
3
Figure 22
Page 12
D S E C R P I T O I N
B O T L 1 4 / 2 - 0 X 3 4 / B S H B K L Z N
NUT 1/4-20 HFLTPLK BLK ZN
E X E T N S O I N C H P I P E R H O P P E R C E
ange nut
at washer
2
GetEarthquake.com
ange nut
ange nut
at washer
at washer
CE/QTY.
1 6
16
2
Figure 23
Figure 24
3
ange nut
at washer
Figure 25
1
hopper extension
1/4-20 bolt
1/4-20 bolt
1/4-20 bolt
1/4-20 bolt
hopper extension
1/4-20 bolt
1/4-20 bolt
1/4-20 bolt
1-800-345-6007