Table of Contents
Advertisement
Quick Links
Silent Boot, Shoe and Glove Dryer
INSTRUCTION MANUAL
IF YOU SHOULD HAVE A QUESTION OR EXPERIENCE
A PROBLEM WITH YOUR DryGuy
Before you call, please have the following information available: Product MODEL number which is located below the UPC code on the
outside of the product box and the store receipt with purchase date. In most cases, a DryGuy
over the phone or via email and if not, can direct you to an authorized service center. If you have suggestions or comments, please send
them via email to: info@dryguy.net. Your feedback is vital to DryGuy
DryGuy
Thermanator
™
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-888-330-9452
CALL 1-888-330-9452
SAVE THIS MANUAL FOR FUTURE REFERENCE
™
PRODUCT
™
™
.
™
DG2
representative can resolve the problem
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DryGuy Thermanator DG2
Summary of Contents for DryGuy Thermanator DG2
- Page 1 Before you call, please have the following information available: Product MODEL number which is located below the UPC code on the outside of the product box and the store receipt with purchase date. In most cases, a DryGuy representative can resolve the problem ™...
-
Page 2: Save These Instructions
Thermanator to rain or snow. ™ ™ • Use of attachments not recommended or sold by DryGuy may result in a risk of fire, electric shock, ™ or injury to persons. • To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting unit. - Page 3 TIPs: 1. Do not place shoes on drying tubes if they are dripping wet as they may drain water on the power cord, creating a potential hazard. Remove as much water as possible before placing on the DryGuy ™...
-
Page 4: Service Information
INfORMATION: DryGuy™ Service Center is staffed with trained personnel to provide customers with efficient and reliable product service. Whether you need technical advice, repair or genuine factory replacement parts, contact customer service at 888-330-9452. -
Page 5: Wall Mounting Instructions
• Guide the stands onto each set of bolts as illustrated (See Fig. 1) and semi-tighten the four self-locking nuts. • Position the stand so the toe of the boot or shoe is the highest point. • Adjust DryGuy Thermanator as necessary to an upright position. - Page 6 (If wall stud spacing is not appropriate for proper mounting, insert the suitable size molly bolt for hollow walls following molly bolt manufacturer’s instructions). • Place clear screw cap cover washer onto screws (See Fig. 3) and securely screw completed DryGuy ™ Thermanator assembly into pre-drilled holes in the wall or molly bolts.
- Page 8 DryGuy.com September 2012...
Need help?
Do you have a question about the Thermanator DG2 and is the answer not in the manual?
Questions and answers