Base - Bell Sonecor Equipment BE-3872 Installation And Operating Manual

LOCATION OF CONTROLS AND FEATURES
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1. Antenna
2. Code Set Key
The [Code Set] key is used to set the answering machine's remote access
code.
3. Time Set Key
The [Time Set] key is used to set the time and day for the voice day/time coding
of each message.
4. Memo Key
Enables recording of a memo message on the answering machine.
5. Erase Key
Press [Erase]during playback to delete an answering machine message.
6. Play Key
To play the messages recorded on the answering machine, press

Base

7 8
Play
9
LOCATION OF CONTROLS AND FEATURES
7. New Message LED
Flashes when new messages have been left on the answering machine.
8. Two Digit Counter Display
Displays the number of messages stored in the answering machine. Also
displays various other information about the base and answering machine.
20.
9. Stop Key
Any current function, such as playback, can be halted by pressing this key.
10. Answer On/Off Key
Press [ANS On/Off] to select between the answer modes "answer on" and
19.
"answer off."
18.
17. 11. Microphone
16.
12. In Use/Low Battery LED
15.
Lights red when the handset is in use. Flashes when the base backup battery
14.
is low or not installed.
13.
12.
13. Repeat Key
Press /Repeat during message playback to repeat the current message.
Also used for scrolling during Time Set, and Code Set modes.
14. Skip Key
Press /Skip during message playback to skip to the next message. Also
11. used for scrolling during Time Set, and Code Set modes.
15. Volume Up/Down Keys L M
The L M keys let you adjust the speakerphone volume.
16. Page Key
Used to initiate a handset page – aids in finding a misplaced handset.
17. Charge LED
Lights red when the handset is on the cradle being charged.
18. OGM Key
Plays back the current outgoing message and allows new outgoing messages to
be recorded.
19. Charging Contacts
Used to recharge battery and reset the security code in the handset.
20. Speaker
.
10