Dell OPTIPLEX 980 Technical Manualbook page 25

Communications – Networking Card
NOTE: MT supports full height card, DT supports low profile card or full height card with optional riser. SFF supports low
profile card.
Broadcom 5722 NetXtreme 10/100/1000 PCIe Gigabit
Card
Connector Type
Data Rates supported
Controller Details
Controller bus architecture (example PCIe 1.0a x1)
Integrated memory
Data transfer mode (example Bus-Master DMA)
Power consumption (full operation per data rate connection speed)
Power consumption (standby operation)
IEEE standards compliance (example 802.1P)
Hardware Certifications (example FCC, B, GS mark...)
Boot ROM Support
Network Transfer Mode (example Full Duplex, Half Duplex)
Network Transfer Rate (example 10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
Environmental
Operating temperature
Operating humidity
Operating System Driver Support
Manageability (examples WOL, PXE..)
Management Capabilities Alerting (examples ASF 2.0 AMT...)
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet
server and network infrastructure is required.
OptiPlex 980 Technical Guidebook
1
Networking MT
10/100/1000 Mbps Half/Full duplex
802.3z, 802.3x, Dynamic 802.3ad,
10BASE-T (full-duplex - 20Mbps,
100BASE-T (full-duplex – 200Mbps,
1000BASE-T (full-duplex - 2000Mbps,
* Depends on the system environment.
0° C to 55° C (32° F to 131° F)
5% ~ 85% (non-condensing)
Windows XP 32-bit, Windows Vista
32-bit, Windows Vista 64-bit, Win7 32-bit,
Win7 64Bit.
WOL, PXE2.1, ACPI, CIM, SNMP
DT SFF
RJ45
PCIe 1.0a x1
40KB
Bus-Master DMA
1.41W (427mA @ +3.3V)
Less than 300mW
802.3 p, 802.1Q
FCC B, VCCI B, CE
No
Full Duplex/Half Duplex
half-duplex – 10Mbps)*
half-duplex - 100Mbps)*
half-duplex – 1000Mbps)*
None
Page 25