SkyLink MS-001 User Instructions

Introduction
The Magnetic Switch works Installation of MS-001 to existing Skylink Security System
1. Remove one of the connection wires from the existing magnetic
in conjuction with the Door/
Window Sensor. You may switch.
use it as a replacement part 2. Connect one of the wires from MS-001 to the existing magnetic
for your current Door/ switch.
Window Sensor, or you 3. Use the provided wire nut to connect the two remaining wires
from the MS-001 magnetic switch and the existing magnetic
can use it as an additional
item to add on to your switch.
existing Door/Window Sen- 4. Position the MS-001 magnetic switch to the door/window frame
sor. Then you can set up using either two sided tape or screws.
these sensors to monitor 5. Position the magnet on the door/window beside the magnetic
switch. They should be no more than 1c m (3/8 inch) apart. When
2 different places using
only one transmitter. the door/window is closed, the magnets are in contact. When the
door/window is opened, contact is broken and the transmitter sends
a signal to the Control Panel to activate the chime or alarm.
Skylink will not be held
liable or responsible for
any misuse or application
MAGNETIC SWITCH
of this product other than
USER'S INSTRUCTIONS
for its intended use.
(Model MS-001)
CUSTOMER SERVICE
17 Sheard Avenue, Brampton,
Ontario, Canada L6Y 1J3
Email:support@skylinkhome.com
http://www.skylinkhome.com
P/N. 101A098-002 Rev. 2
US Patent 6243000B1
©2004 SKYLINK GROUP
Installation
®
Operation
1. Each Door/Window
WT-433 MS-001
Sensor contains 2 parts.
One is the transmitter
(with the test button), the
other is the actual sensor
Magnet
(magnetic switch).
2. Test the unit by pressing
Magnetic switch
the test button on the
transmitter. If the red LED
light turns on, the unit is
ready. Once the contact
is broken, the transmitter
will transmit a signal to
Skylink's receiver(s).
Warranty NOTE
If, within one year from
I f you would like to order Skylink's
date of purchase, this
product or have difficulty getting
product should become
them to work, please :
defective, due to faulty
1. visit our website FAQ section at
workmanship or materials,
www.skylinkhome.com , or
it will be repaired or
2. email us at
replaced, without charge.
support@skylinkhome.com , or
Proof of purchase is
3. call our toll free at 1-800-304-1187
required.
from Monday to Friday, 9 am to
5 pm EST.
fax: 1-800-286-1320